 |
 |
 |
|
ADA GCS-3 NATURAL RESONANCE GUITAR CABINET SIMULATOR AND DI BOX
The all new GCS-3 version! No mics, power amps, guitar cabinets needed. Just take your guitar
signal from your pedal board, preamp or power amp and send
it to the house sound console or board or powered full-range cabinet.
Turn any full-range passive or powered monitor speaker or sound system
into a dynamic guitar cabinet, loaded with your choice of drivers.
Rugged package designed for guitar players and sound engineers who are
looking for high quality analog solutions for live sound reinforcement
systems, stage monitors and recording electric guitar.
Suited for live performance and studio
applications. Faithfully replicates the
low frequency natural resonance of a guitar speaker cabinet at loud
volumes, which is especially noticeable in the SEALED CABINET
configuration.
The GCS-3 is inserted between the output of your preamplifier (or
effects pedal chain) and a mixing or recording console to replace the
close proximity microphone that is typically used to mic a guitar
speaker cabinet. This eliminates the problem of bleed through or
crosstalk from other instruments or amplifiers in live situations.
We have tested the GCS-3 in live performances by sending a feed to a
stage monitor for the guitarist and eliminating the combo or head with
stack. The same feedback that you get from a stack or a hot-rod combo
can easily be produced in the monitor, and interestingly, with more
control.
Features:
- Power Amp Direct Connect (ONLY IN GCS-3 VERSION)
- Headphone Output and Volume Control (ONLY IN GCS-3 VERSION)
- Selectable 10� or 12� Speaker Size
- Selectable VINTAGE (Alnico) or MODERN (Ceramic) Speaker Character
- Selectable OPEN BACK or SEALED Cabinet Type
- Variable MICROPHONE PLACEMENT Control to �position� the mic for deep or bright frequency response.
- �� phone jack INPUT with a direct, un-buffered PASS THROUGH �� phone
jack. This effectively splits the signal to feed both a guitar
amplifier (the THRU) and a mixing console (one of the outputs, either ��
phone single ended or XLR balanced)
- XLR Balanced Output has selectable LINE or MIC LEVEL Output and a GROUND LIFT for Pin 1
- Pure Analog Circuit Design using thru-hole, low-noise components
- Rugged all-steel chassis with durable powder coat finish
- Powered by a single industry standard 9-volt AC Adapter, but runs internally at 18 volts for higher headroom and lower noise
- Designed and manufactured in California
VIDEO DEMOS:
|
|
|
 |
|
 |
|
|
|
